XADO Revitalizant EX120 for diesel engines
Revitalizant EX120 for diesel engines
Designed to protect against wear and restoring repair of diesel engines, including high-power and turbonadduvom.Blagodarya by 20% * greater concentration of the active substance has more headroom to restore worn surfaces and to protect them from wear.
* To the product HADO gel revitalizant for diesel engines.
Forms on the friction surfaces cermet coating (engine parts restore their original geometry). As a result a renovated unit exceeds the performance a new one and is 2-4 times longer.
- Restores and protects friction parts from wear of the cylinder group, crank and gas distributing mechanisms
- Significantly reduces fuel consumption (up to 30% at idle)
- Increases to the rated pressure of the oil in the system
- Levels and increases compression in the cylinders
- Increases engine power and improves throttle response
- Reduces noise and vibration by 10 times
- Increases component life by 2-3 times
- Protects the motor from the negative consequences of the "cold start"
- Improves engine operation in 50-100 km
- Allows you to use engine oil leakage up to 300 km
After the treatment, your car is under superzaschitoy HADO.
In the operation of the engine most subject to wear sleeve assembly in the top of the "dead" spots, the details of timing (the cam follower), plain bearing crankshaft and camshafts.
Revitalizant contains a building material that compensates for wear of these parts. As a result of revitalization on the friction surfaces formed a new multi-functional gradient coating with the set of service characteristics and stress states.
Details of the engine are increasing in volume, and restore those "hundreds" and "ten", which have been lost, worn out in service. This effect repairs. The resulting coating has unique properties: considerable strength, high corrosion resistance and low surface roughness. After the revitalization of the engine parts are guaranteed to last for 2-4 times longer.
As a result of revitalization of the engine is greatly increased and leveled compression in the cylinders is reduced fuel consumption, increased throttle response and the car rolled forward, recover oil pumps, turbo components, shafts and bushings (bearings), mirrors cylinders, eliminating ellipse. The engine is quiet and vibration-free. Thanks to the revitalization it can always be maintained in perfect condition.
The order of application
Treatment of the engine is carried out in three stages.
Stage 1: The contents of the syringe into the oil mouth to make the engine warmed up to operating temperature. Start the engine and let it idle for 5-10 minutes.
Step 2: Repeat the same procedure after 100-250 km run.
3rd stage: to be held in the same order after 100-250 km run.
The treatment is completed in no less than 1,500 kilometers
|Volume of engine oil system, l.||3-10||11-20||21-30|
|The number of syringes (8 mL), pcs.||3||6||9|
|Treatment scheme||1 1 1||2 2 2||3 +3 +3|
|Syringes for new engines||2||4||6|
- Oil until it is not recommended to change
- Treatment can be done at idle (4 hours - equivalent to 200 km run)
- New engines with a mileage of up to 20 000 km treated in one step
- Engines overhauled recommended to treat as normal in three stages
- Protective cermet coating is formed on any working mechanism, however, if the mechanism (engine) is in critical condition (100% wear), it is necessary to replace the damaged parts
Syringe Applicator, 8 ml